Heating Mode Switch
It is used for operating the heating device. If the switch is off,
the heater for hot water is not worked.
Cooling Mode Selection Switch
It is used for operating the cooling device. If the switch is off,
the compressor for cold water is not worked.
Hot Water Drain-Outlet
It is used for draining water out of the
hot water tank.
Indication Lamp of Overheating
When the temperature of hot water is over the setting
temperature(95 ), the lamp is flickering and the thermostat
cuts off the power of heater. As the temperature of hot water
goes down below the setting temperature, the lamp goes out.
Indication Lamp of Low Water Level
It indicates the shortage of purified water in the main tank.
Indication Lamp of Cold Water
Temperature
It indicates the cold water temperature at present.
Indication Lamp of Hot Water
Temperature
It indicates the hot water temperature at present.
Indication Lamp of Cooling Mode
It indicates the cooling mode is selected.
Indication Lamp of Heating Mode
It indicates the heating mode is selected.
�
�
�
�
�
�
●
●
●
●
●
●
●
●
●
�
�
�
Indication Parts
Operating Parts
Safety Information
Operating Instructions
T
roubleshooting T
ips
Customer Service
Safety Information
Operating Instructions
T
roubleshooting T
ips
Customer Service
07/08
Draining hot water from the outlet,
be careful not to be scaled.
℃
WARNING
Summary of Contents for Nurisu CHP-01BL
Page 1: ......
Page 18: ...WATERFLOW DIAGRAM NOTE Exclude boost pump LPS and check fitting on CHP 01BL CHP 01BR CHP 01BU...
Page 20: ......
