Coway CHP-04AR, User Manual

Page: 34 / 44

33
Water Filtration System Performance data Sheet
brand: metro model: CHP-04Al
This system has been tested and certified by the Water Quality Association according to NSF/ANSI 42, 53, and 58 for
the reduction of the substances listed below. The concentration of the indicated substances in water entering the
system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as
specified in NSF/ANSI 42, 53, and 58
Substance
Max. Allowable
Concentration
(mg/L)
Average
Influent
(mg/L)
Average
Effluent
(mg/L)
Minimum
Percent
Reduction (%)
Average
Percent
Reduction (%)
Arsenic (Pentavalant) 0.010 0.05 0.006 79.1 87.7
Barium 2.0 10 1.4 83.5 86.6
Radium 226/228 5pCi/L 25pCi/L 5pCi/L N/A N/A
Cadmium 0.005 0.031 0.002 89.0 92.7
Chromium (Hexavalent) 0.1 0.358 0.023 93.8 95.1
Chromium (Trivalent) 0.1 0.367 0.028 93.8 95.7
Lead 0.010 0.153 0.005 93.6 95.1
Nitrate/Nitrite 10 29.6 4.8 78.5 83.7
Selenium 0.05 0.117 0.003 96.0 97.8
TDS <187.5 741.5 55.1 90.0 92.6
Aesthetic Chlorine
INNOSENSE ≥ 50% 2.07 0.56 54.53 72.8
FINE POST CARBON ≥ 50% 1.96 0.53 55.0 72.8
VOC*
INNOSENSE ≥ 95% reduction 0.327 0.0052 96.20 98.4
FINE POST CARBON ≥ 95% reduction 0.317 0.005 96.2 98.5
While testing was performed under laboratory conditions, actual performance may vary.
General Operating information:
Rated Capacity
INNOSENSE FILTER
359 gallons (for VOC)
7,523 gallons (for Aesthetic Chlorine)
FINE POST-CARBON
402 gallons (for VOC)
1,453 gallons (for Aesthetic Chlorine)
Min-Max operating pressure: 20 ~ 120 psi (14 ~ 8.4 kgf/cm
2
)
Min-Max feed water temperature: 41 ~ 95 ºF (5 ~ 35 ºC)
Rated Service Flow
0.07 GPM (for VOC)
0.5 GPM (for Aesthetic Chlorine)
Daily Water Production Rate 53.3 GPD
Product Efficiency Rating 31.0 %
Electrical Requirements: 120 Vac / 60Hz
• Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection
before or after the system.
• Refer to the owners manual for specific installation instructions, manufacturer’s limited warranty, user
responsibility, and parts and service availability.
• The influent water to the system shall include the following characteristics:
o No organic solvents
o Chlorine: < 2 ppm
o pH: 7 - 8
o Temperature: 41 ~ 95 ºF (5 ~ 35 ºC)
o Iron: < 2 ppm
o Turbidity: < 1 NTU
o Hardness: < 1000 mg/L