Covidien Nellcor OxiMax N-560, Service Manual

Page: 59 / 158

Troubleshooting
N-560 Service Manual 49
Data Port
Table 10 lists a symptom for data port problems and recommended actions. If
the action requires replacement of the User Interface PCB, refer to
Disassembly Guide
on page 53.
Error Codes
When the N
-
560 detects a defective sensor connected to the N-560, the N-560
displays an error code of “SEN Err.” The sensor should be replaced and the
N-560 power should be cycled.
An error code is displayed when the N-560 detects a non-correctable failure.
Cycling the power clears these errors. Table 11 lists the N-560 error codes
and their meanings. When one of these errors occur, the N-560:
• sounds a low priority alarm that cannot be silenced except by
power-down
• stops measurements
Table 10: Data Port Problems
Symptom Recommended Action
No printout is being
received.
The N-560 is running on battery power. Connect the
N-560 to AC power.
The N-560's baud rate does not match the printer.
Change the baud rate of the N-560 following
instructions in the Operator’s manual.
Check the connection between the data port and the
printer. Refer to Connecting To The Data Port on
page 97.
Replace the Front Panel PCB. Refer to
Front Case
Disassembly on page 57.