Covidien Nellcor OxiMax N-560, Service Manual, Page: 48 / 158

Audible Alarm Settings and Service Functions
38
If an invalid tone is heard instead of the triple beep, the current settings were
not changed. An invalid tone is a single low-pitched tone.
Note
: Current values will not be stored in memory as institutional defaults if
power is interrupted before exiting this menu option.
Note
: When the operator changes an alarm limit to a value other than a
institutional default value, a decimal point is displayed to the right of the
parameter whose alarm limit was changed.
Menu Item 10 (Restore Factory Default Settings as Power-On Default)
Menu item 10 resets the N-560 to factory default settings as shown in Table 4,
three confirmation tones will be heard.
After menu item 10 has been selected, cycle power to the N-560 and verify
that the factory default values have been reinstated.
.
Alarm silence restrictions None, sound reminder, do not allow alarms off
Blip volume 0 to 10
Language English
Serial port baud rate 2400, 9600, 19200
Serial port mode ASCII, external equipment communications
Event in-sensor trend format SpO
2
, SpO
2
and pulse rate
RS-232 nurse call polarity Normally high, normally low
Table 3: Institutional Default Values (Continued)
Parameter Range
Table 4: Factory Default Settings
Parameter Range
Factory
Default
Setting
%SpO
2
Upper Alarm
Limit
Lower Alarm Limit plus 1 to
100%
100%
%SpO
2
Lower
Alarm Limit
20% to Upper Alarm Limit
minus 1
85%
Pulse Rate Upper
Alarm Limit
Lower Alarm Limit plus 1 to
250 bpm
170 bpm