1723 W. 4th Street Tempe Arizona 85281
P
: 800.638.6104
|
F
: 480.966.6728
|
E
|
www.covid.com
USER MANUAL
Page 5
6. Mode:
The Update Mode and the RS-232 mode selector .
Update Mode:
When the dial switch is set to update, port 7 is used to update or control the device .
RS-232 Mode:
When the dial switch is set to RS232, port 7 is used for RS232 pass-thru communication .
7. RS-232:
RS232 communication port that passes through from transmitter to receiver and receiver to
transmitter .
8.
Connection Signal Indicator Lamp
•
On (Solid):
The Transmitter and Receiver are communicating .
•
Flashing:
The Transmitter and Receiver are not communicating properly .
•
Off:
The Transmitter and Receiver are not connected by a category cable .
9.
Data Signal Indicator Lamp
•
On (Solid)
The HDMI signal is carrying HDCP .
•
Flashing:
The HDMI signal is not carrying HDCP .
•
Off:
No HDMI signal .
HDBaseT Receiver With Audio Extractor - RBH-220
EDID MODES
The RBH-220 can use an internal EDID from memory instead of the EDID provided by the display . Capturing
the EDID from the display is the default mode of operation of the RBH-220 . This EDID will change based on
what display device is connected to the RBH-220 . The internal EDID has been pre-loaded in case there is a
compatibility issue with the display EDID for the connected sources . To change the EDID mode, flip the mode
switch on the back of the device to update mode and send the command for setting the EDID mode from the
RS232 command table . Defualt system EDID support1080P .