RF Remote
The RF remote makes it convenient to switch inputs at
distances up to 75 feet. The buttons on the remote be-
have in the same manner as the Front Panel keypad but-
tons.
To use your remote, make sure the DIP switch ID bits on
both the CVD 5206/5216 and the CVD 550R match.
They are both defaulted to be ‘0’ ‘0’ from the factory.
A slide switch on the side of the remote is provided to
greatly extend battery life when the remote is not in use.
Set the slide switch to the ON position. Now, press a but-
ton. The display on the CVD 5206/5216 should change
to match the button pressed.
The DIP switch ID bits are provided in case you have
multiple units and need to control them separately or all
at once using the RF remote. The RF remote must be
opened to change the ID bits. The ID bits on the CVD
5206/5216 are externally accessible. When not using the
remote, set the slide switch to the OFF position.
RF Remote Battery Replacement
To replace the battery, the case must be opened. Press
on the tab of the battery holder to pop out the opposite
end of the battery. Carefully remove. Carefully slide one
end of the new battery under the tab. Gently press the
battery into the socket. The battery is a 3V lithium coin
type battery, CR2032 size.
10
RS232 Messages
The CVD 5206/5216 RS232 routine sends feedback messages to
the user. Each character typed is echoed back to the terminal. Some
of the messages provide helpful information when using the CVD
5206/5216. Messages are enclosed in square brackets. [ ]
Character Message ‘?’ -- Unknown Command
•
Applies after an unrecognized character or bad command.
•
Sent after an [Enter] key or a full command buffer.
Character Message ‘$’ -- Good Command
•
Applies after a recognized command.
•
Sent after an [Enter] key or a full command buffer.
After a good/bad command, the unit will return a prompt on a new
line. After this message, the PC command must be reentered from
the beginning.
String Message ‘Switch Video *’
•
Applies after a complete command has been recognized.
•
Sent after an [Enter] key and a valid command.
•
A switch has been made to the input designated by the *.
String Message ‘Video Showing is *’
•
Sent after a status command.
•
Tells the user what input is current being shown.
String Message ‘Program User Mode *’
•
Sent after a program command.
•
Entering program mode for storing a user preset designated
by the *.
String Message ‘Program Mode ON’
•
Sent after a program command.
•
Entering program mode for storing a user preset.
15
