Page 7
For technical questions, please call 1-888-866-5797.
Item 63297
Square up the Frame
TO PREVENT SERIOUS INJURY: Contact local utility companies to ensure that the installation area is
free of pipes, cables, and other hazards BEFORE choosing installation area or installing anchors.
1. Position the frame in the desired location,
making sure it is level and flat.
2. Measure between diagonal corners.
These
measurements must be within 1″ of each other.
3. Measure across front and back.
These
measurements must be 10' each.
4. If any measurements do not match, adjust the frame
and measure again until measurements match.
Anchor the Frame
WARNING!
Anchor only according to these instructions. Improper assembly
or inadequate anchoring can create hazards.
CAUTION!
To prevent tripping hazard, position Anchors toward
the interior of the frame, close to the Corner Feet.
1. Use a metal bar (sold separately) to thread the
Anchor (14) into the ground, until
the loop at the
top of the Anchor extends just above the ground.
Note:
When anchoring to concrete, use
Concrete Anchors (not included).
2. Insert a Wire Rope (23) through the
Anchor and Corner Foot.
3. Tighten the Wire Rope and secure it
using a Wire Rope Clamp (24). Tighten
the nuts on the Clamp evenly.
Wire Rope
(23)
Interior
of Frame
Wire Rope
Clamp (24)
4. Repeat on the other corners.
Note:
Center Feet may be anchored to increase stability.
SAFETY
MAINTENANCE
ASSEMBL
Y
