ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
TGS64SW
-WM
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard any of the packaging until you have checked that you have all the parts and pack
of fittings.
Keep children away during assembly. This item contains small parts which can be swallowed by
children. Children should always be under direct adult supervision while using the product.
Retain the assembly instructions for future reference.
Please quote following FQC NO. when contacting service center.
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
PAGE 1 OF 2
COURTYARD CREATIONS INC.
!
!
!
!
!
!
STOP
DON’T RETURN TO STORE!
PARTS LIST
PART
NO.
MATERIAL CODE
PART
Q’TY
1
1
2
3
4
5
7
6
8
9
10
11
4
2
8
4
4
4
1
4
1
6
TGS64SW-CS01
TGS64SW-CS02
TGS64SW-CS03
62TGS64SWY101
17C17A0403001Y4
17C33A0709001Y4
17C01A0709001Y4
17FA05040301-Y4
1800337004
1800337001
17KAA0101----Y4
TABLE TOP
LEG
SUPPORT
CENTER
CONNECTOR WITH RING
SCREW ST4.2*12
BOLT M6*25
BOLT M6*25
WASHER d6.5*D13*1.0
BOLT CAP
BOLT CAP M6
HEX.KEY WRENCH 4MM
FIGURE 1
You will need the following tools:
- Phillips Screwdriver (Not Included)
- Hex. Key Wrench (See Part #11)
Step 1:
Place the table top (#1) onto a non-abrasive surface,
such as a carpet, with its underside facing upwards.
Insert the legs (#2) and supports (#3) into the plastic
holders on the table top (#1) rim. Fasten them together
by using screws (#5). See Figure 1.
Attention:
Make sure that each bolt needed for all steps match the
corresponding figure to ensure proper assembly.
1
2
2
2
2
3
3
5
