ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
PARTS LIST
TGS39SW
-
WM
PART
NO.
MATERIAL CODE
PART
Q’TY
PART
NO.
MATERIAL CODE
PART
Q’TY
1
7
8
2
3
4
5
6
PAGE 1 OF 2
COURTYARD CREATIONS INC.
!
!
!
!
!
!
!
1
4
1
4
4
4
4
1
FIGURE 1
LEG
SCREW ST4.2*12
CENTER
CONNECTOR WITH RING
BOLT M6*25
WASHER d6.5*D13*1.0
BOLT CAP
HEX.KEY WRENCH 4MM
17FA05040301-Y4
17C33A0709001Y4
18000337004
17KAA0101----Y4
TGS39SW-CS01
TGS64SW-CS02
62TGS39SWY101
17C17A0403001Y4
TABLE TOP
You will need the following tools:
- Phillips Screwdriver (Not Included)
- Hex. Key Wrench (See Part #8)
2
2
2
2
1
4
Step 1:
Place the table top (#1) onto a non-abrasive
surface, such as a carpet, with its underside
facing upwards. Insert the legs (#2) into the
plastic holders on the underside of the table
top (#1) rim. Fasten them together by using
screws (#4). See Figure 1.
Use the correct bolts as indicated. Do not tighten any of the bolts until is completely assembled.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC NO. when contacting the service center.
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
STOP
DON’T RETURN TO STORE!
