DYNA-CUT
17
SETTING UP SCRAP SEPARATOR
1. In order to be able to separate the scrap you will
need vertical channels in the die for the diverter
fingers to ride on. The number of fingers required
will depend on sheet size and thickness.
2. Line up diverter fingers with channels in the die.
3. Set the diverter bar into slots and tighten set screws
4. Run single sheet to check position of diverters and
insure proper scrap diversion.
5. If not properly aligned you will get a paper jam
which you will need to clear. Turn off the machine or
press the e-stop button before attempting to clear
jam.
6. Make necessary adjustments retest until you get a
clean diversion of scrap.