16
Password Configuration
1. To prevent information leakage, you can set the reading and writing
password through programming software.
2. Each time you read or write, you must enter the correct 8-digit
password before operating.
3. To cancel the password, clear the password and confirm.
4. To change the password, key in the old password first, and then
enter the new password to rewrite.
5. When you forget the password, you can perform factory reset or
reprogram it.
Sub-Code Configuration
1. The sub-code frequency supports CTCSS, DCS positive code, DCS
reverse code, standard sub-code and non-standard sub-code.
2. Only when the transmitting sub-code and receiving sub-code are
the same can they communicate to each other.
3. A radio with sub-code can transmit to radio without, but cannot
receive signal without sub-code.
Scan List Configuration
1. The scan list can contain analog channels and digital channels.
2. After configuring the scan list, the scan switch should be turned on.
3. Turn on/off the scan list through menu operation or the preset [P1/
P2] key.
4. After scanning is turned on, a scan icon will flash on the screen.
5. During scanning, the channels scanned include the channels in the
scan list and the current main channel.
6. When any channel in the scan list is transmitting a signal, it will stay
on that channel upon signal detection.
功能介绍
Features
功能介绍
Features
