Coto baby stars q, User Manual

Page: 12 / 44

7
GB
PRODUCT ASSEMBLY
TABLE ASSEMBLY
1. Lay one table side on its side ensuring that the inside is facing up. 6
2. Align the table top&table cross bar & table connecting rod onto the table side, use
the assembly tool (part P), screw plastic screw caps (x5) (part O) until secure. 7
3. Flip the unit over align another table side onto table top & table cross bar & table
connecting rod use the assembly tool (part P), screw plastic screw caps (x5) (part O)
until secure. 7
NO NOT! Over tighten the plastic screw caps.
TRAY ASSEMBLY
WARNING! Never use the high chair without the tray t-bar properly installed.
1. To install the tray T-bar: slide the tray T-bar into groove on bottom of the main tray
until the locking tab snaps into place. Pull gently on the tray to ensure it is secured in
place. 9
2. To remove tray T-bar: press down on the locking tab and remove.
3. Put the insert tray onto the matching posiotion of main tray. 10
USING HIGH CHAIR
Ensure that both the chair and table are properly assembled and all plastic screw
caps.
1.
Turn the table around make sure the table top is perpendicular to the ground.
2. Insert the legs of the chair into corresponding holes of the tabletop. 11
3. Squeeze the adjustment tabs on each side of the (underside) of the Main tray while
sliding the main tray into the guides on the top of the chair sides until secure. 12
4. There is one upright position and one reclined backrest position on this chair, adjust
the backrest position by pushing the green handle up on the rear of the backrest.
Move the backrest to the desired position and release the green handle. 13
5. Ensure that the seat is locked into position before placing child in high chair.
REMOVING/INSTALLING CHAIR PAD
1. Release the harness buckle by pressing the center button. 14
2. Unthread the waist belt from the latch plates by pressing buttons on the sides of
the buckles and pulling belt out. 15