1.User’s Guide For CR8 Remote Controller
1-1. Features
：
：
Remote ON/OFF inverter operation
Ignition lockout information display and Return Override Function Acting
1-2. Specification:
Input Voltage Range: 10.5 – 60 Vdc depends on Inverter model.
Operating Temperature Range : 0 – 40
℃
Storage Temperature Range : - 30
℃
- 70
℃
Stand-By Current Draw : < 40mA
Applicable Models : ST / SK / SD / SE
series
1-3. Introduction
：
：
●
This is a simple ON / OFF remote control.
＊
Steady red LED light in dicates the Inverter is ON.
＊
Fast flashing red LED light indicates that it is in Return Override Function selection status.
＊
Slow flashing red LED light indicates that it is in Ignition Lockout Function selection status.
●
The wire JP1 is placed inside the remote controller and it is to indicate either
Return Override
Function
or
Ignition Lockout Function
.
＊
JP1 jumper “Open” –
Return Override Function
＊
JP1 jumper “Short” –
Ignition Lockout Function
Please note that the default mode is OPEN.
●
The wire must go with a 12 Volt 0.5A fuse with proper sizes.
●
Connect the wire RJ-11 to the remote port in front of the panel.
＊
Ignition Lockout function
– The Ignition lockout function is to turn the Inverter OFF when
the auxiliary input wiring is connected to the ACC. (accessory), and 12 Volts is applied.
＊
Return Override Function
– The
Return Override Function
is to turn the Inverter ON when
the auxiliary input wiring is connected to the reverse gear Shift, and 12 Volts is applied.
●
Installation Procedure
：
1. Refer to the drawing (see Figure 1) for screw hole and cutout dimensions.
2.Use the cable between CR8 remote and the inverter.
3.Switch the inverter to REMO position.
Inverting
R.O.F Acting
Ignition
INVERTER REMOTE
Blinking Fast
Blinking Slow
Solid Red
ON/OFF
PUSH
Inverter Status
(INTERNAL)
PIN
JUMPER
TO
INVERTER
AUX. +12V
