29
E
N
CX SERIES BATTERY CHARGER
The above suggested battery charger selection is based on battery capacity multiply 0.2~0.3. Example: 100Ah battery
* 0.2 / 0.3 = 20A~30A in this case please select CX2425
3.14 Battery voltage setting suggestion
•
GEL TYPE (Max. Voltage of 14.1 / 28.2 Volt)
•
AGM TYPE (Max. Voltage of 14.4 / 28.8 Volt)
•
Lead-Acid (Max. Voltage of 14.8 / 29.6 Volt)
3.15 Fan speed duty description
The fan determined by load and heat sink temperature.
1.
Fan speed 100%: comply with one of the following conditions
•
a. Load ≥ 75%
•
b. Load ≥ 50% and heat sink temperature ≥ 50
•
c. Heat sink temperature ≥ 75C˚
2.
Fan speed duty 50%
:
•
a. Heat sink temperature ≥ 67.5C˚or
•
b. Set CX to sleep mode by setting DIP4 (Refer to 3-2) when 1. a, b, or c applies
3.
Fan speed duty 0%
:
•
a. Load < 75% and heat sink temperature < 35C˚or
•
b. Sleep mode turned on by CR-1
4 Installing charger
When selecting the installation location, observe the following instructions:
Do not install the charger in following situations:
•
In wet environments
•
In dusty environments
•
In the vicinity of combustible materials
•
In areas where there is a danger of explosions
The place of installation must be well ventilated. A ventilation system must be available for installations in small, enclosed space. The clearan-
ce around the device must be at least 25cm.The air inlet on the underside and the air outlet on the back of the device must remain clear.
•
For ambient temperatures higher than 40 C˚ (such as in engine or heating compartments, or direct sunlight), the heat from the charger
under load can lead to reduced output.
•
The charger must be installed on a level and sufficiently sturdy surface.
•
Do not install the charger in the same area as the batteries.
•
Do not install the charger above batteries, because they can emit corrosive sulphur fumes that will damage the device.
Notice!
Before drilling any holes, make sure that no electrical cables or other parts of the vehicle can be damaged by
drilling, sawing and filing.
For installation and mounting you will need the following tools:
•
Pen for marking
•
Drill bit set
•
Drill
•
Screwdriver
To secure the charger in place you will need:
•
Machine bolts (M4) with washers and self-locking nuts or
•
Self-tapping screws or wood screws
•
Fasten the charger as follow:
•
Hold the charger against the installation location
•
Mark the fastening points
•
Fasten the charger with one screw through each hole in the holders
