Cotech ND-189, Original Instructions Manual, Page: 6 / 44

6
EN
G
LI
SH
Instructions for use
Note
Bear in mind that factors such as the size of the room, the outside temperature
and how well the building is insulated, all affect the ability of the heater to warm
the room up. If the room is too large the ability of the heater to warm it up to
the desired temperature may be insufficient.
1. Place the electric stove on a firm, level floor surface.
2. Plug the product into a wall socket.
Flame effect without fan heater function
1. Set the [ I/0 ] switch (E) to I to switch the stove on, the flame effect comes on.
2. Set the [ I/0 ] switch to
0
to switch the stove off, the flame effect will go out.
Flame effect plus fan heater function
1. Set the [ I/0 ] switch to I to switch the stove on, the flame effect comes on.
2. Turn the thermostat knob (H) clockwise to the maximum setting.
3. Press in [ I ] (F) to select 1000 W or press in both [ I ] and [ II ] (G) to select 2000 W.
4. When the desired ambient temperature has been reached, slowly turn
the thermostat knob back until it clicks and the fan heater switches off.
Leave the thermostat knob in that position.
5. The stove will maintain the set temperature by automatically switching on and off.
6. The temperature can be adjusted by turning the thermostat knob:
- clockwise to raise the temperature
- anticlockwise to lower the temperature.
7. Set the [ I/0 ] switch to 0 to switch the stove off, the flame effect will go out.
Overheating protection
The electric stove is fitted with an overheating safety cut-off protection device which
switches the appliance off if it overheats. To reset the overheating protection device:
1. Set the [ I/0 ] switch to
0 .
2. Unplug the stove from the wall socket and let it cool for at least 15 minutes.
3. Then plug the heater back into a wall socket. The heater should now work normally.
Care and maintenance
• Switch the stove off, unplug it from the wall socket and let it cool before cleaning.
• Clean the exterior of the stove using a soft cloth. Dampen the cloth with a little
water if required, do not use detergent, solvent or corrosive chemicals.
• Get into the habit of vacuum cleaning the air inlet and outlet regularly.
• Store the stove indoors when it is not in use.
• The lights inside the electric stove are LEDs and cannot be replaced.