Content:
E
C
D
.
.
.
SET-UP STEPS
IMPORTANT: DO NOT USE EXCESSIVE FORCE DURING ANY PART OF SET UP
1. Stand frame upright. Starting at the corners, with partner
standing on the opposite side, grasp the two outer legs,
slightly lift the frame off the ground and step backward,
stopping at full arms’ length.
2. Unfold the fabric canopy pack, place the fabric top over
the top frame. Use the velcro pads to secure each
corner of the cover to the frame under the plastic caps.
3. Each partner should then grasp the bottom of the
middle frame section(cross beams) where it forms
diamond. Lift slightly and slowly walk backward
until the frame is fully extened. Be careful not to
pinch your finger or pull backward too hard as this
may result in the bending of cross beams.
4. Engage the slider at each corner by pushing up
the slider with one hand while holding down the top of
the leg with the other hand. Repeat this operation at
remaining corners.
5. To secure the fabric top to the frame, please wrap the
velcro loop straps around roof tubes and cross beams.
6. Pull down the inside valances to cover the beam tubes
velcro the adjacent valances together for clean look.
7. Lift two adjacent outer legs and pull out inner legs
gently until spring loaded snap button pops in position.
Repeat on the remaining legs.
WARNING:
Keep all flame and heat sources away from this tent fabric.
Always read and follow the instructions before use. Be
cautious to avoid pinching your hands or fingers in any
of the moving parts as frame opens and closes.
The gazebo is designed to provide shade only. Do not use
this gazebo in strong wind and rain. Wind and rain can damage
the gazebo and could result in injury to you and others.
