04
05
REF. NO
1
2
3
4
5
6
7
8
9
10
SIZE: 142* 30 INCH
10
10
10
10
10
1
1
3
3
1
DESCRIPTION
J-SHAPED HORIZONTAL BEAM
VERTICAL LEG
END CAP
PIN
LEG CAP
POOL LINER(DRAIN VALVE CAP INCLUDED)
BELT
STRAINER HOLE PLUG
FILTER MASK
DRAIN CONNECTOR
POOL SETUP
Before assembling your product, please take a few minutes to check the
contents and become familiar with all the parts.
WARNING
· DO NOT overfill the pool or allow people to lay over or
sit on pool wall - DOING so CAN CAUSE PERMANENT INJURY!DRAIN pool to
the proper level after a heavy rain.
TIP:
It will be much easier to install your pool if you unfold it and let it lay
in direct sunlight for about 2 hours prior to installation. This will help to
ensure a wrinkle-free fit because the pool material will be more pliable
allowing it to form into shape during installation.
WARNING
-VERY IMPORTANT! SITE MUST BE LEVEL, STABLE,
COMPACTED SOIL.
- The pool must be assembled on a smooth and level site of firm soil that
is free of stones, gravel, sticks, blacktop, or other oil base compounds.
- Before setting up your pool, it is recommended that you clear the area of
hard grasses. Certain types of vigorous grasses such as St. Augustine and
Bermuda can grow through the liner. A ground cloth or tarp may be helpful
in preventing this from occurring.
- Do not install pool on a wooden deck or any type of wooden surface. You
cannot use sand and/or uncompacted soil to provide a level surface for this
pool; it will only wash out.
-FAILURE TO FOLLOW ALL OF THESE INSTRUCTIONS WILL CAUSE POOL
TO COLLAPSE!
SETUP INSTRUCTIONS
1.Locate a level and flat area to set up the pool. Make sure the ground is
free from stones, branches, or other sharp objects as they may puncture
the pool.
2.Take out the ground cloth and spread it over the cleared area, then take
out the pool liner and spread it over the ground cloth, inspect the seams.
3.lt is recommended to assemble the pool after the pool liner is heated by
the sun.
IMPORTANT:
Always set up the pool unit with at least 2 persons. Do not
drag the lineracross the ground as this can cause liner damage and pool
leakage.
4. Insert the Vertical Legs
into the Leg Caps, then insert
the end cap into the head of
the vertical leg.
5.Lay all parts on the
ground as shown
below. Check the parts
listing and be sure all
the pieces to be
assembled are
accounted for(see
picture).
