08
09
8. Pull the restrainer straps out from under the liner. Put the "inverted T"
side leg end cap into the restrainer strap, insert the side leg into the head
of the "inverted T" side leg end cap, and finally insert the side leg into the
upper T-joint.
9. Before filling the pool with water, ensure that the drain plug inside the
pool is closed and that the drain cap on the outside is screwed on tightly.
Fill the pool with no more than 1 inch (2.5 cm) of water. Check to see
whether the water is level. IMPORTANT: If the water in the pool flows to
one side, the pool is not completely level. Setting up the pool on unleveled
ground will cause the pool to tilt resulting in the sidewall material to bulge
and a potential collapse of the pool. lf the pool is not completely level, you
must drain the pool, level the area and re-fill the pool, following the above
directions.
10. Fill the pool with water up to just below the sleeve line.
