Reset the unit by unplugging the
unit from power source for 5
minutes and then plug it back.
Use it closer to the unit / change
battery / remove insulating plastic
sheet.
Error Code 88 shown on the
indicator
Remote control does not work
TROUBLE SHOOTING
Problem
Solution
The unit does not turn on
Flame effect is on, but there is no
flame effect
Make sure the unit is plugged into
a standard 120V grounded power
source. Press the power button on
the control panel.
Open the top and back panel to
check if the flame spindle has
fallen off from the spindle motor.
Make sure the set temperature is
higher than the room temperature.
The heater does not blow warm air
Turn all switches to OFF and
unplug the unit for 5 minutes.
Plug the unit back to power and
operate as normal.
The heater does not work
29
Summary of Contents for FP10104US
