04
05
ELECTRICAL SAFETY:
●
Do NOT override the timer switch.
●
Do NOT operate in standing water .
●
Do NOT overload with garments.
●
Do NOT cut-off or restrict air circulation.
● Do NOT expose to rain or snow.
● Use of attachments not recommended may result in a risk of fire,
electric shock, or injury to persons.
●
To reduce risk of damage to electric plug and cord , pull by plug rather
than cord when disconnecting unit .
●
Make sure cord is positioned so that it will not be stepped on , tripped
over or otherwise subjected to damage or stress.
● Two-wire cord can be used with 2-wire extension cord. Only round
jacketed extension cord should be used and we recommend that they be
listed by Underwriters Laboratories (U.L). If the extension cord is to be
used for indoor use. The letters “W” or “WA” on the cord jacket indicate
that the cord is suitable for outdoor use.
●
An extension cord must have adequate wire size (AWG or American Wire
Gauge)for safety and to prevent loss of power and overheating. The
smaller the gauge number of the wire, the greater the capacity of the
cable; that is, 16 gauge has more capacity than 18 gauge. When using
more than 1 extension to make up the total length, be sure each
extension contains at least the minimum wire size.
●
This appliance has a polarized plug (one blade is wider than the other).
To reduce the risk of electric shock ,this plug is intended to fit into a
polarized outlet only one way. If the plug does not fit fully into the
outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to modify the plug in any way.
OPERATING INSTRUCTIONS:
1. Plug the
boot dryer
into any standard 120 Volt 60 Hz electrical outlet
2. Unfold the 4 anti-slip pads under the bottom base, and pull up the
upper tubes when drying boots up to 16” tall.The
boot dryer
dries boots
and gloves together or 2 pair of long boots and other types of shoes
simultaneously by pulling up the two upper stretchable tubes directly.
Push the two sides’ locking buttons simultaneously and slide down the
upper tubes if you wish to faster drying.
Front two smaller tubes are
specially designed for drying kids shoes or boots or socks or gloves.
3. The upper tubes with anti-being pulled off system will prevent the tubes
falling put when pulling off the long boots after drying.
4. Carefully slide footwear onto drying tubes or drying
nozzles, being
careful
not to restrict air flow at the bottom or block air flow into the
lower assembly.
5. Select the heat or no heat setting by pressing the rocker switch at the
top of housing
6. Turn timer knob clockwise to the 180 minute mark to initially activate
the timer switch (please note as this is very important), then turn knob
counter-clockwise back to desired drying time.timer will auto off.
7.
When turn on the UV/Ozone switch to sterilization, please do make sure
open all the windows or doors for good air circulation to avoid any
potential harm to your lung healthy. DONOT USE THE STERILIZATION
FUNCTION IN A CLOSED ROOM/CONFINED SPACE OR BED ROOM, KEEP
IT AWAY FROM THE KIDS OR DISABLE PEOPLES!
Optional function:
If your machine is made with UV/Ozone sterilization function,Please switch
ON the independent switch besides the Timer dial to turn ON the
UV/OZONE generator to produce the UV/OZONE for sanitizing your
shoes.if donot want UV/OZONE ,just turn OFF the switch independently for
drying function only.
CAUTION:
PLEASE DONOT CLOSE TO THE MACHINE AND BREATH OVER
15MINS IF TURN ON THESTERILIZATION FUNCTION TO AVOID POTENITAL
HARM TO YOUR LUNGS.PLEASE KEEP AWAY FROM THE MACHINE AND
OPEN THE WINDOW OR DOOR FOR VENTILATION DURING OR AFTER
STERILIZATION.
▲
ANNOUNCEMENT :
● The boot dryer generates a gentle breeze,a light wind that evenly dries
garments that will not damage your boots.
It is not a hair dryer and is
not designed to force a powerful current of air through garments.
●
The
boot dryer
only heats to a gentle temperature.It is not designed to
generate high heat as this would damage footwear.
SAVE THESE INSTRUSTIONS
