Inflation
1. Open the compressor compartment and pull out the air hose.
2. Place the nozzle over the valve and press it right down. Fold down the locking
lever into the locked position.
3. Start the compressor with the compressor power switch.
4. Monitor the air pressure on the manometer until the desired pressure is
reached.
5. When the desired pressure has been reached, turn off the compressor with the
power switch, fold up the locking lever and disconnect the nozzle from the
valve. Replace the hose in the compressor compartment.
6. Use an adapter to inflate beach balls, air mattresses, inflatable boats etc.
INVERTER
●
The inverter can supply 120VAC, 60Hz, 200W.
●
To protect the battery, the inverter is fitted with under voltage protection. If the
voltage falls too low, an alarm will be emitted and the inverter will be switched
off. It will be reset automatically when the battery voltage is higher.
●
The inverter is fitted with short-circuit protection, which switches off the jump
starter if the connected equipment short-circuits.
●
If the indicator light on the inverter comes on, check that the connected
equipment is working correctly and does not need too much power for the jump
starter. Also check the charge level in the battery.
●
The fuse trips in the following situations. Replace the fuse if necessary.
- If the connected equipment needs too much power.
- In the event of a short circuit in the connected equipment.
1. Set the inverter power switch to the ON position.
2. Insert the cable from the external equipment into the 120V outlet.
3. Start the external equipment.
4. The inverter can be switched off automatically or with the power switch.
08
