Costway EP24453, User Manual

Page: 9 / 24

loosening of hinges and latches, (5) evidence of dropping or abuse.
(c) Before turning on microwave power for any service test or inspection
within the microwave generating compartments, check the magnetron,
wave guide or transmission line, and cavity for proper alignment, integrity,
and connection.
(d) Any defective or misadjusted components in the interlock, monitor, door
seal, and microwave generation and transmission systems shall be
repaired, replaced, or adjusted by procedures described in this manual
before the oven is released to the owner.
(e) A microwave leakage check to verify compliance with the Federal
Performance Standard should be performed on each oven prior to release
to the owner.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit,
grounding reduces the risk of electric shock by providing an escape wire for
the electric current. This appliance is equipped with a cord having a
grounding wire with a grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded.
WARNING – Improper use of the grounding can result in a risk of electric
shock. Consult a qualified electrician or serviceman if the grounding
instructions are not completely understood, or if doubt exists as to whether
the appliance is properly grounded, and either:
1) If it is necessary to use an extension cord, use only a 3-wire extension
cord that has a 3-blade grounding plug, and a 3-slot receptacle that will
accept the plug on the appliance. The marked rating of the extension cord
shall be equal to or greater than the electrical rating of the appliance, or
2) Do not use an extension cord. If the power supply cord is too short, have
a qualified electrician or serviceman install an outlet near the appliance.
. INSTALLATION ……
…………………………..……… .…
1. Take out all the packing. if there is a safe film over the oven, tear it off
before Use. Check carefully for damage. if any, immediately notify
dealer or send to the manufacturer’s service center.
2. Microwave ovens must be placed under dry and non-corrosiveness
environments, kept away from heat and humidity, such as gas burner
or water tank.
3. To ensure sufficient ventilation, the distance of the back of microwave
to the wall should be at least 10 cm, the side to the wall should be at
least 5 cm, the free distance above the top surface at least 20 cm. the
distance of the microwave to the ground should be at least 85 cm.
7