EN
1
）
Carefully remove plastic wrap and cardboard packing and cut plastic
band.
2
）
Open bed and remove parts for assembly.
3
）
Closed bed and snap clip-lock bar using slots (1) and (2 as shown in
illustration.Do not use slot (3).
4
）
Lay folded bed on one side (See picture n°1)
5
）
Open two center legs (See picture n°2 )
6
）
Place the flat side (top) of the leg cross-bar (item E) against the
bottom of the central leg,align holes,insert caster (A) into hole and
secure using nut (B).Repeat with remaining three casters (See picture
n°3)
7
）
Stand bed upright and insert the four plastic leg caps (C) by inserting
the center tabs into the holes on the outside legs (See picture n°4)
1)Unfold legs by pulling each leg upward until it is perpendicularar to
side of folded bed.
2)Release the Clip-Lock Bar on top of folded bed by grasping finger hold
at one end and pulling upward.When Clip-Lock Bar releases,lower one
side of the bed until leg rests on floor.Then.lower opposite side of bed
until leg rests on floor and bed is fully opened.
3)Once the outer legs are fully extended,secure retention brackets from
the frame to extended outer legs (see picture n°5)
After use,fold bed and secure with Clip-Lock Bar for easy storage.
NOTE:AS CLIP-LOCK IS RELEASED.HOCD HANDLES ON TOP OF
BED TOPREVENT BED FROM OPENING TOO RAPIDLY.
TO USE BED:
08
Summary of Contents for 87145392
Page 5: ...1 2 05 ...
Page 6: ...3 4 06 ...
