Turn the table right side up.
Adjust the pre-installed Levellers at the end of each table leg until the table is level with the
ground.
Securely, tighten and fasten all the screws and washer-nuts.
Your table is now ready for use.
Step 3
NOTE : To HOLD the legs together in positon, the LONG and SHORT LEGS SUPPORT
PANELS WILL OVERLAP AT ALL 04 (four) CORNERs.
Proceed to affix the Long and Short Legs Support Panels (B&C) to the table legs with
Blots(D),Washers and Spring Washers(E).
Do not over tighten, yet.
Repeat the same process for all 08 (four) contact points of the Table Legs and the Legs
Support Panels.
Once all the panels are in place, go back to tighten the screw-bolts of the legs in step 2.
Tighten these bolts to the legs in a sequential direction.
By this, it allows the table legs to be locked into position evenly, thus reducing wobbles.
Thereafter, tighten up all screws in all the Leg Support Panels tightly into position.
{ Please note the direction of the table top pattern to the Leg Supports (B&C). }
Step 4
4 OF 5
Summary of Contents for CAST TABLE
Page 5: ...5 OF 5 ...
