Cosori CO108-NK, User Manual

Page: 9 / 16

9
USING YOUR KETTLE
Boiling Water
High Altitude Users
1. Add at least ½ cup / 118 mL of filtered
water to the kettle.
Do not fill above the
“ MAX ” line. Wipe any water from the
outside of the kettle and the base.
2. Put the lid on the kettle and make sure
it fits securely. Place the kettle on the
power base.
3. Plug in the cord. The button lights will
blink, and the base will beep once.
4. Press (“ ON / OFF ”). The button will
light up.
Note: The kettle will turn off after 1
minute of inactivity.
Note: If you take the kettle off the base
during Hold Temperature mode, the
(“ HOLD TEMP ”) button will blink. After 60
seconds, the kettle will turn off.
Note:
• Use filtered water for perfect pour over
brewing.
• If you start the kettle without water in it,
the kettle will turn off and controls will be
disabled. See
Boil-Dry Protection (page
10).
Note:
• You can only select 1 preset at a time.
• If you take the kettle off the base while
heating, all buttons will turn off, and
the kettle will pause heating. If you put
the kettle back within 60 seconds, it will
resume heating. After 60 seconds, the
kettle will turn off.
5. Press to choose a preset temperature
setting. The button will light up, and
the kettle will start heating up the water.
6. Optionally, press (“ HOLD
TEMP ”) any time before the kettle is
finished heating. This will turn on
Hold Temperature mode, which will
automatically keep the kettle at the
same temperature for 60 minutes after
heating is finished. The button will stay
lit during that time.
7.
When the water is at the preset
temperature, the kettle will beep 3
times and stop heating.
At higher elevations, water boils at a lower
temperature. You may need to use a
different preset.
Altitude Preset for Boiling
Water
3,881–9,255 ft /
1,183–2,820 m 205°F COFFEE
9,256 ft / 2,821 m
and above 195°F OOLONG