8
9
Turntable Installation
Installation
3.0 inch(7.5cm)
3.0 inch(7.5cm)
12 inch(30cm)
OPEN
Remove all packing material and
accessories. Examine the oven for any
damage such as dents or broken door.
Do not install if oven is damaged.
Countertop Installation
Cabinet:
Remove any protective film
found on the microwave oven cabinet
surface.
Do not remove the light brown
Mica cover that is attached to the oven
cavity to protect the magnetron.
1.
Select a level surface that provides enough open space for the
intake and/or outlet vents.
Never place the glass tray upside down. The glass
tray should never be restricted.
Both glass tray and turntable ring assembly must
always be used during cooking.
All food and containers of food are always placed
on the glass tray for cooking.
If glass tray or turntable ring assembly cracks or
breaks, contact your nearest authorized service
center.
A minimum clearance of 3.0 inches (7.5cm) is required between
the oven and any adjacent walls. One side must be open.
-
Leave a minimum clearance of 12 inches (30cm) above the oven.
-
Do not remove the legs from the bottom of the oven.
2. Plug your oven into a standard
household outlet. Be sure the voltage
and the frequency are the same as
the voltage and the
frequency on the rating label.
WARNING: Do not install oven over a range cooktop or other
heat-producing appliance. If installed near or over a heat source,
the oven could be damaged and the warranty would be void.
Blocking the intake and/or outlet
openings can damage the oven.
Place the oven as far away from
radios and TV as possible.
Operation of microwave oven may
cause interference to your radio or
TV reception.
A) Control panel
B) Turntable shaft
C) Turntable ring assembly
D) Glass tray
E) Observation window
F) Door assembly
G) Safety interlock system
F
G
A
C
B
E
D
SETTING UP YOUR OVEN
Names of Oven Parts and Accessories
Remove the oven and all materials from the carton and oven cavity.
Your oven comes with the following accessories:
Glass tray 1
Turntable ring assembly 1
Instruction Manual 1
Hub (underside)
Glass tray
Turntable ring assembly
Turntable shaft
