PRE-INSTALLATION PROCEDURES
7
U
PRE INSTALLATION PROCEDURES
•
Please read the instructions carefully. Unpack the Range Hood and check that all
functions are working before installing.
•
Ensure that the voltage (V) and the frequency (Hz) indicated on the sticker match the
voltage and frequency at the installation site.
•
Check that the area behind the installation surface to be drilled is clear of any electrical
cables or pipes, etc.
•
The stainless steel surfaces of the Range Hood are very easily damaged during
installation if scratched or bumped by tools. Please take care
to protect the surfaces
during installation.
•
Protect the cooktop surface below with cardboard, or the like, to prevent damage
occurring during installation.
•
The manufacturer shall not be held liable for consumer’s failure to observe and follow
all pre-installation procedures and safety regulations.
•
Determine if your installation will be top venting or back venting, and ensure that the
openings in the cabinet or wall are in the appropriate locations and appropriate size,
as per Fig. 1 for top vent installation or Fig. 2 for back vent installation.
•
If this is a new installation, choose the venting method that suits your needs. Cut out
openings for the damper and for power access in the cabinet bottom or exterior wall,
depending on the direction of venting chosen.
Fig. 1
•
The vertical distance from the cooking surface to the bottom of the range hood should
be atleast 24 in. to 36 in. for best performance.
8
Ducted Mode
Recircula�ng
Mode
Ducted Mode:
Turn
the
knob to this se�ng
for Ducted Installa�on.
Recircula�ng Mode: Turn
the
knob to this
se�ng for a Recirula�ng Installa�on.
•
Please read the instructions carefully.
Unpack the Range Hood and check that all
functions are working before installing.
•
Ensure that the voltage (V) and the frequency (Hz) indicated on the sticker match the
voltage and frequency at the installation site.
•
Check that the area behind the installation surface to be drilled is clear of any electrical
cables or pipes, etc.
•
The stainless steel surfaces of the Range Hood are very easily damaged during
installation if scratched or bumped by tools. Please take care to protect the surfaces
during installation.
•
Protect the cooktop surface below with plywood, or the like, to prevent damage
occurring during installation.
•
The manufacturer shall not be held liable for failure to observe all safety regulations.
IMPORTANT
!
READ BEFORE INSTALLATION
!
You will need to set the Range Hood mode to either Ducted or Recirculating.
1. Remove Aluminum Filters
2. Locate Knob Settings located under the Motor
(Fig.
3
)
3. Rotate the lever to either Ducted or Recirculating mode.
4. If
recirculating mode
is chosen, install the vent cover on the rear vent hole.
If
ducted mode
is chosen, install the damper on the vent hole where the air will vent
through (top or rear), and install the vent cover on the other vent hole (shown on Fig.2
of the previous page).
Fig.
3
Venting mode
