8
DTV Converter Box
9
DTV Converter Box
USER’S MANUAL
USER’S MANUAL
4. Installation and channel set up
You can choose one of the two ways below (
not both
) to install and scan digital TV
channels
1) To receive digital channels with MD output (RF output)
(RF cable is included in the package)
Connect outdoor or indoor antenna to the “ANT IN” of the rear panel
Connect the converter box (MD output) and TV set (RF/ATN in) with
RF cable
Turn on the TV set, tune to
channel 4
(or channel 3, but the converter system sets
channel 4 as default)
Power on the converter box by putting the
power switch
to
“on”
of rear panel
Tune the converter box to
“operation”
mode, by pressing
key on the
remote control (when in “operation” mode, LED on front panel is
GREEN
)
Press
“menu”
button on the remote control to enter main menu, select
“channel scan”
, press
“OK”
button to start channel scan, when the scan
finishes, channels will broadcast automatically, then press
“exit”
button on
remote control to close the menu and enjoy the digital TV programs.
***
Analog pass through
Do above and below steps, it will allow you to watch analog channels with analog
pass through function:
If you would like to transfer to analog channels(if available), you just need to tune the
converter box to “
Standby
” mode and the analog signal will pass to the TV set
through the converter box, means the TV will receive analog channels. Please note
that when you are watching analog channels, you need to use the TV’s remote
control or front buttons for channel operation. If you would like to come back to digital
channels, you need to tune the converter box to “
operation
” mode.
