8.1 Mounting method
■
Fig.8.1
Mounting method
When implementing the power supply to the printed circuit board, please fix the power
supply to the printed circuit board by screw before the soldering.
If it is screwed to the substrate after soldering, there is a possibility of failure by adding
mechanical stress to the soldering point and the internal connections of power supply.
A-17
Heat sink
Heat sink
retention screws
Silicone grease
/ Heat dissipation sheet
Power supply
Power supply
retention screws
Power supply
soldering
printed circuit board
2.1 Pin configuration
8. Mounting method
①
②
Applications Manual
TUNS300/500/700
