Cosatto supa 2018, Manual

Page: 8 / 44

EN
5
Drink holder 26- Fitting:
Removal is a reversal of this procedure.
Raincover 27- Fitting:
Removal is a reversal of this procedure.
Seat cover Removing:
28-
Release primary lock (1) & secondary folding lock (2).
29- Release fabric fasteners at rear of backrest (1).
30-
Rotate “C” clip to expose gap (1) and slide waist strap out (2).
31- Fold retainer flat (1) and push through slot in mounting block (2).
There are three retainers on each side of the pushchair. One on the front
chassis tubing (3) and two on the underside of the seat (4).
32-
Disconnect “C” clip from under seat (1).
33- Disconnect double “D” ring strap under the calf support (1).
34-
Slide seat cover off calf support end (1) and off the backrest tubing (2).
35- Prior to washing, unzip the top of the backrest section (1) and remove the
three backrest boards (2).
Refitting is a reversal of this procedure.
Pushchair 36- Closing:
Ensure backrest is in the upright position (Refer to step 15 ).
Always remove the raincover, placing it in the basket and close the hood
completely.
Pull the ring upwards (1) then press down the secondary lock bar (2).
Push the handles forward (3) until the auto lock engages (4).
Note:
Take care not to damage the stand mechanism when folding.
Pressing down too hard on the pushchair can bend the stand arms (5).
Stand 37-
The stand automatically unfolds when the pushchair is closed.
Note: To avoid injury ensure that your child is kept away when the
pushchair is used in free-standing mode.