Cosatto hootle, Instruction Manual

Page: 9 / 45

20 - removing the harness, seat liners and seat cover - 1
Remove the upper and lower seat liners.
Unfasten the harness straps and remove the chest pads (See Step 6 for Group 0+ chest
pads. See Step 15 for Group 1 chest pads.)
Unfasten the harness buckle. Remove the clips from the end of the harness straps (a).
Locate the crotch strap clip under the seat. Push the clip through the seat (b & c).
Note: The adjuster strap is not intended to be removable.
21 - removing the harness, seat liners and seat cover - 2
Starting on one side carefully pull the cover off from around the seat (a), the adjuster
button and strap (b).
Pull the cover off the harness straps (c).
Once the cover is removed feed the harness straps through the slots in the seat base
(d & e).
22 - refitting the harness, seat liners and seat cover
Feed the harness straps through the slots in the seat base as shown (a & b) until the
length of each end of the harness strap protruding through the seat is equal. Ensure the
straps are not twisted.
Note: The folded over end of the strap
MUST
be facing upwards as shown (c).
Feed the harness straps through the slots in the seat cover (d).
Fit the seat cover over the adjuster strap and adjuster (e).
Refit the cover by carefully stretching the material over the edge of the seat (f). Ensure the
support plates on the side of the seat cover fit into the channels in the seat base (g).
Refit the remaining parts of the harness (A reversal of the procedure in Step 20). Ensure
the straps are not twisted before use.
Refit the seat liners.