4/8/2015
INS5329
CORSA Performance
·
140 Blaze Industrial Pkwy
·
Berea, OH 44017
·
P: (440) 891.0999
·
F: (440)
891-1868
6
E - M a i l :
s a l e s @ c o r s a p e r f o r m a n c e . c o m
· w w w . c o r s a p e r f o r m a n c e . c o m
Cat Back Exhaust System
Single Side Exit w/ 4.0
” Pro-Series Tips
2015+ Ford F150
PN 14836 & 14836BLK and 14837 & 14837BLK
Installation of CORSA Exhaust System:
NOTE:
Apply the anti-seize lubricant
(supplied)
to the threads ONLY of all the clamps and flange bolts. Failure to
follow this procedure can cause nuts to seize on clamps and potentially destroy threads. After applying anti-seize
lubricant, be sure to thoroughly clean your hands, as lubricant will tarnish stainless steel. All clamps should be
tightened using a properly calibrated Torque Wrench. Using an air impact gun will
damage the clamp and reduce its ability to effectively seal the joint. It may also
cause the joint to separate, thereby causing damage to your exhaust system and
to your vehicle.
NOTE:
Align all clamps so that the center of the clamp bolt is 90 degrees from the
notch in the pipe. (See Fig. CLAMP)
1.
Remove all exhaust components from the shipping carton, including the 2 supplied 3” clamps.
2.
Locate the CORSA Performance muffler and align the inlet to the stock resonator outlet along with the front muffler
hangers to their corresponding grommets. Insert the muffler inlet into the resonator outlet along with the rear
hangers.
(5.0L - Fig K) (2.7L & 3.5L Fig L)
Note:
The use of a soap and water solution may aid in the installation of the hanger grommets.
3.
Rotate the stock resonator so that the drain hole, located on rear endcap, is towards the ground. Once the drain
hole is in proper position, snug the factory clamp connection using a 15mm socket and ratchet.
(Fig M)
4.
Locate a 3” Torca clamp and install it over the expanded end of the tailpipe.
(Fig N)
Slide the tailpipe over the rear
axle and position the tailpipe hangers in-line with their corresponding hanger grommet assemblies. Once the
tailpipe is positioned slide the tailpipe assembly forward to install the hangers.
(Fig O & P)
Note:
Removing the rear tailpipe grommet assembly from the vehicle and installing it on the rear tailpipe hanger
beforehand may simplify the installation, but is not required if the tailpipe is positioned correctly.
5.
Insert the muffler outlet pipe into tailpipe inlet, properly position the clamp and snug it using a 15mm deep socket
and ratchet.
(Fig Q & R)
6.
Locate the tip assembly and 3” Torca clamp. Properly align the clamp onto tip inlet and install tip onto tailpipe
outlet.
(Fig S & T)
Snug the clamp using a 15mm deep socket and ratchet.
(Fig U)
CONTINUED ON NEXT PAGE