© Corroventa Ltd.
2017.02
16 (25)
How to network machines
In order to network machines to use for instance the pressure drying mode of the dehumidifier,
proceed as follows:
1.
If the machines are powered, switch them off and then proceed by connecting the machines
with system cables. The two connectors on the machines have the same functionality so it
does not matter which one is used. If SuperVision is to be used, this too must be connected
to one of the machines, it does not matter which one.
2.
Power up the machines.
3.
Select what machine shall be master, for use of pressure drying mode, this shall be the
Turbine set to push the dry air into the construction.
If networking the units with the only purpose of having them monitored and remotely
operated through SuperVision, it does not matter what machine is selected as Master.
4.
On the selected Master machine, use right arrow button to step to the Network menu
depicted below.
(If this menu is not found, the machine is set to Basic menu setting. To change this, select
Setup and Maintenance menu and change the menu system setting to Advanced.)
5.
In the Network menu, push <Create> and then wait while the machine sets up the network.
6.
When the network is created, at the top of the screen the presentation will toggle between
the different slaves. If SuperVision is connected, the text SuperVision will be presented at
the bottom of the screen although it can take up to a minute before this is shown.
After having followed the steps above, all the slave machines are now controlled by the Master.
This means that they will all be started and stopped with the Master. They still work with the
same settings they had before the network connection so if these need to be changed, push Edit
and then select the slave to be edited through the Master or do the necessary changes to the
settings on the machine itself. When being edited through the Master, the slave machine will
start to blink its display backlight so that the user can see what machine is selected.