Page of 14
11
ASSEMBLY (Continued)
18. Going up the vertical cylinder securement panel (Item 25), align the pre-drilled holes in the left side
with the pre-drilled holes in the lip of the middle shelf (Item 5). Secure each mounting hole with a 10
mm bolt and a nut. Repeat for both holes and then again for the one on the back. Then repeat for all
three mounting holes on the right side of the vertical cylinder securement panel (Item 25).
19. Align the pre-drilled holes on the back of the top shelf lip (Item 1) with the pre-drilled holes in the
vertical cylinder securement panel (Item 25). There is one on the back and one on the side for both
the right and left sides (Items 1 & 25). Secure with a 10 mm bolt and a nut. Leave these slightly loose
at this time.
20. Align the pre-drilled holes on the front of the top shelf lip (Item 1) with the pre-drilled holes in the front
vertical panels (Items 3 & 24). Secure with a 10 mm bolt and a nut. Then tighten all the bolts from the
previous step.
NOTE: The tow handle (Item 2) is reversible. The orientation of the handle will vary depending on the
equipment and operator preference.
21. Using the longer 10 mm bolts, slide on a flat washer and slide it through one of the pre-drilled holes
on the left side of the handle (Item 2). Then slide it through the matching pre-drilled hole on the left
lip of the top shelf (Item 1). Add a flat washer, lock washer, and secure it with a nut. Leave this nut
slightly loose at this time. Repeat for both pre-drilled holes in the left side of the handle (Item 2).
Then repeat for the two mounting holes in the right side of the panel Items 2 & 1). Then tighten all the
nuts holding the handle.
22. You will notice four pre-drilled holes remain in the front vertical panels (Items 3 & 24) and on each
side of the vertical cylinder securement panel (Item 25). These mounting holes are for cable wraps
(Item 4). For the top set of holes, the cable wrap (Item 4) should be mounted with the opening up.
For the bottom set of holes, the cable wrap (Item 4) should be mounted with the opening down.
Using a 10 mm nut, slide it through the pre-drilled holes in the cable wrap (Item 4) and then through
the pre-drilled hole in the vertical panel(s) (Items 3 & 24). Secure with a nut. Repeat this for all
mounting holes on all eight cable wraps (Item 4) on both side of the cart (Items 3 & 24, Item 25
respectively).
23. Find the 3/4-inch holes in the back of the vertical cylinder securement panel (Item 25). Place one end
of the securement chain (Item 23) in one hole and slide a link down into the bottom groove. Then
wrap the chain (Item 23) around the cylinder you are securing and place it in the other 3/4-inch hole
on the other side of the vertical cylinder securement panel (Item 25).