CSE1500 3 04/16/20
CSE1500
1500 Lb. Engine Sling
OPERATING INSTRUCTIONS
This is the safety alert symbol used for the OPERATING INSTRUCTIONS section of this manual to alert you to potential personal injury
hazards. Obey all instructions to avoid possible injury.
The load leveler is designed to be used with a portable shop crane to handle and position engines and other large vehicle components. The drive
screw adjusts the sling's lift point in relation to the mounting chains to compensate for off-center loads, or adjusts to a certain angle for component
removal or installation.
1. Attach the shop crane's hook or attachment device to the oval link at the top of the sling's lifting block. Make sure the connection is secure.
2. Lift only on the areas of the engine or component as specified by the vehicle manufacturer. Make sure that all four chains are securely fastened to
the load.
3. Before lifting make sure that all fuel and electrical lines and components are clear of the load.
4. Lift the load just high enough to locate the center of balance or the desired angle in which the load can be removed. This adjustment is
accomplished by turning the sling's drive screw in a clockwise or counterclockwise rotation.
PREVENTATIVE MAINTENANCE
This is the safety alert symbol used for the PREVENTATIVE MAINTENANCE section of this manual to alert you to potential personal injury
hazards. Obey all instructions to avoid possible injury.
IMPORTANT: Any leveler found to be defective as a result of worn parts due to lack of lubrication is not eligible for warranty consideration.
1. Always store the leveler in a well protected area where it will not be exposed to inclement weather, corrosive vapors, abrasive dust, or any other
harmful elements.
2. The leveler must be lubricated periodically in order to prevent premature wearing of parts. A general purpose grease must be applied to the threads
on the screw.
3. Every sling owner is responsible for keeping its label clean and readable.
4. Do not attempt to make any repairs unless you are a qualified repair person that is familiar with this equipment.
PARTS BREAKDOWN
Worm Shaft
Fulcrum
Hex Adjusting Nut
NOTE: each replacement chain available separately as Part# RSESCHAIN
Also available: product label kit, Part #RSCSE1500PLK
