005-201, Issue 1
STANDARD RECOMMENDED PROCEDURE 005-201 | ISSUE 1 |
OctOber
2013 | PAGE 1 OF 5
SSt-Drop™ cable Hybrid
Assemblies with Pulling Grip
related literature |
006-111
Instruction, Optical Access connector cleaning Kit
1.
Planning
this procedure describes a general method for accessing SSt-Drop™ cable hybrid assemblies
with pulling grip. SSt-Drop cable hybrid assemblies are outside plant cables with an Optitap
®
connector on one end and a Sc APc connector on the other. the Optitap connector features a
protective cap, which can accommodate a pull line, and is secured against loss by a lanyard. the
Sc APc connector is captured inside a pulling grip to accommodate a pull line and protect the
connector during installation.
2.
Components
Figure 1 provides a pictorial description of the components of an Optitap
®
Preconnectorized Drop
cable.
Figure 1
3.
Unpacking Flat-Profile Drop Cables
Optitap Preconnectorized Drop cables are shipped coiled in a box.
WARNING:
Unrestrained cable ends may
cause injury to your eyes or body and can
damage the cable, fitting, or fibers if
suddenly released from a coil. Wear eye
protection and use extreme care when
handling a coiled cable assembly which
uses flat-drop cable — gently release the
energy stored in the cable coil to avoid
possible personal injury or damage to the
cable or fitting components.
KPA-1463
Figure 2
KPA-1636
