STANDARD RECOMMENDED PROCEDURE 003-813 | ISSUE 3 | SEPTEMbER 2015 | PAGE 7 OF 8
Step 1:
Remove the blank panels from the unit and replace with connector panels
(purchased separately).
Step 2:
Route buffer tube around the radius control guides (Figure 9 boxed inset)
to determine length required for buffer Tube Fanout (bTF) body (purchased
separately).
Step 3:
Prepare the cable and insert fibers into BTF body per the directions provided with it.
Step 4:
Secure bTF body to the rear of the drawer with a cable tie as seen in Figure 9.
Step 5:
Route pigtail slack around the radius control guides.
Step 6:
Clean connectors and adapters per standard company practices and mate
connectors in the adapters as shown in Figure 9.
3.4 Installing Splitter Modules
Step 1:
Remove the radius control guides and the blank adapter panels.
Step 2:
Install the splitter modules (purchased separately) in place of the blank panels
(Figure 10).
Step 3:
Route the input fiber through the notch in the panel to the front jumper trough.
Continue routing the input fiber through the routing clip to its destination.
Step 4:
Route the output fibers through the routing clip to their destinations.
Figure 10
Input Fiber
Output Fibers
Notch for
Input Fiber
KPA-2440
