CORNING
LSE
DIGITAL MICROPLATE AND ORBITAL SHAKERS
USER’S MANUAL
7
POWER
RPM
TIME
RUN
nx10 (RPM)
t (min)
Push
Time/RPM
RUN and TIME signal lights on. Shaker runs and counts down time from set value.
NOTE: YOU CANNOT MODIFY THE SET TIME DURING SHAKING, HOWEVER, YOU CAN STOP
THE UNIT WITH THE START/STOP BUTTON AND THEN RESET THE TIME.
POWER
t (min)
nx10 (RPM)
RUN
TIME
RPM
Push
Time/RPM
If you want to change the RPM during shaking, push the encoder knob to put the shaker into
RPM set mode (RPM signal light will be on). Rotate the encoder right (+) or left (-) to set the
desired value. In the meantime, the RPM signal light will flash. When you stop rotating the
encoder knob, the signal light for RPM will stop flashing after 2 seconds.
POWER
t (min)
nx10 (RPM)
RUN
TIME
RPM
Push
Time/RPM
When the run time has elapsed or when you press the START/STOP button, the display will
show “End” and the RUN light will flash. When shaker completely stops the set speed and
time will return to the last programmed values.
