CONTROLS
PRE-AMP
INPUT
Jack plug input connection for your electric guitar.
High impedance input connection for instruments.
VOLUME
Adjusts the gain of the pre-amp and is used to set the
overall volume of the amplifier.
The volume control also acts as a switch, when pulled the switch
defeats the tone circuit. This adds middle and gain.
PULL EQ CUT
This is a bypass for the tone controls (tone stack). The tone controls do not operate
and you will find a large increase in gain.
TREBLE
The treble control increases the high frequency response.
BASS
The bass control increases the low frequency response.
EDGE
The Edge control adds extra bite to the tone.
OUTPUT STAGE
OUTPUT SWITCH
This switch alters the output power: Position A=7 Watts,
position B=1 Watt, position C=1/4 Watt position D=1/8 Watt
Note that, unless the volume is adjusted above the power
selected, you will not notice any change in output level.
OUTPUT
The output jack socket is connected to an 8 Ohm internal
speaker.
MAINS INDICATOR
When illuminated, there is power to the amplifier.
MAINS FUSE
The fuse holder contains the mains fuse for the amplifier. The
mains fuse protects the amplifier from electrical faults.
HT FUSE
(located on the speaker side of the chassis)
Protects the output valve.
Replace a failed fuse only with the same type and rating.