OPERATION INSTRUCTION
CARE AND CLEANING
Before cleaning: disconnect from the power and allow to cool, remove
lid and empty any water.
Wipe with a damp cloth and mild detergent then wipe dry with a soft
cloth. Never use any chemical, steel wool or abrasive cleaners to clean
the exterior of the unit. It will damage the surface.
Clean regularly with a sponge or damp cloth.
Dry with a soft cloth.
The interior can become discolured because of deposits of limescale
and particles after porlonged use. This is not harmful to health, but
may be cleaned as follows:
1. Fill with water, adding 30g of citric acid or some lemon slices.
2. Start boiling water and then keep water warm at 85
o
C for 3-4 hours.
3. Then empty the unit, normally the limescale will all gone.
4. Before back to normal use the unit, it’s recommend to fill the unit
then boil and emptied again to wipe of the acid smell/taste.
TO CLEAN THE EXTERIOR
TO CLEAN THE INTERIOR
OVER-HEATING PROTECTION
If unit start boiling without fill in water(dry-boil), the temperature
inside will go up untill trigger the over-heating protection.
In this condition, the unit will shut down automatically, alll indicator
lamp will turn off. To make the unit back to normal status,
fill in cold water and wait till the “Boilling” lamp back to flash.
Remove all package and labels before using the unit
BOILING WATER
1. Press “Keep warm setting” to select demand keep warm temp.
SETTING KEEP WARM TEMPERATURE
2. The temp. lamp will keep flashing till the water reach demand
temp and then stay on.
1. Open the lid and fill water till the full mark.
2. Close the lid tightly and plug in the power cord to wall power.
3. “Boiling” lamp will flash indicate it’s in the standby mode.
4. Press the “Power on/off” button to start boiling.
5. “Boiling” lamp will stay on indicate the boiling is process.
6. When the boiling is finish, “Keep warm” lamp will stay on.
After finish boiling, press the “Power on/off” button to activate the
standby mode to allow water cool down naturally to room temp.
In the standby mode, the “boiling” lamp will stay in flash.
The default keep warm temp. is 55
o
C.
*
*
*
WATER DISPENSE
The water dispense function is workable in standby mode.
*
1. Press “Unlock” button to unlock the unit.
2. Press “Dispense” button to obtain water.
UNLOCK
POWER
ON/OFF
