4
Before First Use
Please read these instructions carefully before using and keep them for future
reference.
Check your local mains voltage to make sure it is the same as stated on the
appliance.
Carefully unpack the unit and remove all packaging materials. Check the contents to
ensure that all parts and accessories are present and received in good condition.
Handle the blending blade attachment by its collar only.
WARNING: Do not touch blades. Blade attachments are very sharp. Use extreme care
when handling the blades. Failure to do so can result in personal injury.
Wash lids in warm, soapy water. Rinse and dry thoroughly.
Clean tumblers before first use. Fill tumbler one-quarter full with clean, warm water.
Following the steps under Operating Instructions, pulse several times using the
blending blade. Rinse thoroughly.
The motor base can be wiped with a damp cloth.
WARNING: DO NOT IMMERSE THE MOTOR BASE IN WATER.
Always make sure the plug is inserted to the power outlet tightly before use.
Always ensure the product is placed on a stable and flat surface.
Operating Instructions
1.
Place the motor housing on a flat, clean and dry countertop or table.
2.
Make sure the unit is unplugged.
3.
The unit comes with two (2) tumblers. Place the food to be blended in the tumbler.
4.
To assemble the appliance, always hold the blade assembly by its collar before
placing it onto the tumbler.
IMPORTANT:
Check to make sure the travel lid is not attached to the tumbler before assembling
the blade. If it is, simply remove it.
At the base of the blender’s collar, there is a silicon seal that creates an airtight fit
with the personal blender’s tumbler. After washing in a dishwasher and before each
use, always make sure the seal is in its proper place, as heat from some dishwashers
may cause the silicon seal to become loose.
WARNING: Never operate the personal blender when the tumbler is empty.
WARNING: Never overfill the tumbler. Do not exceed the 600mL maximum line.
5.
Hold the tumbler firmly in one hand. Use the other hand to tighten the tumbler and
blade assembly by turning the blade collar clockwise until snug.
6.
Plug the power cord into the power outlet.
7.
Invert the tumbler with blade assembly. Insert blade collar into the motor base,
fitting the tabs into the slots on the motor base.
8.
Turn the blade collar clockwise to secure the locking slots firmly into the motor base.
NOTE: The unit will not operate unless the 2 locking tabs on the motor base are
properly fitted into the 2 slots on the blade collar.
