5
How to assemble
Open the package and take the appliance out. Connect to the
electrical outlet after removing the foam cover.
Open the water tank cover on the lower back of the appliance
and add water into the water tank (Figure 1). Observe the
water level through the watermark to control the water amount
(Figure 2).
Pay attention to the following
When adding water, pay attention to the water level indicator at
the front of the appliance.
Do not over fill water above the red water level line.
Close the cover when finished adding water, otherwise the
appliance will not work.
If you want to reduce more temperature, you can add ice into
the water tank.
Instruction of “ICE PACK”
The appliance is packaged
with two unique “ice packs”. The ice
packs are specially used for keeping cool. It can absorb the
energy of water little by little, keeping the temperature of the
water at around 18
0
C, lower than that of the ambience. This
makes the wind cooler.
Operation Method
Put the ICE PACKS into the refrigerator and keep them inside
until they are completely frozen.
Put one ice pack into the water tank. Close the cover. The
temperature of the water will be 8
0
C lower than that of the
ambience and this will be maintained for 4 hours, making the
wind cooler.
The two ICE PACKS can be re-used continuously.
On/Off Key
“ON/OFF” key is used for starting and stopping the appliance.
Wind speed starts from medium speed and will change to low
speed 3 seconds later.