Manual Installation Conversion Kit 4.1 To 4.2
Publication Number: 629097805INS
- 10 -
©2019, Cornelius Inc.
22. Mount new display assembly onto door key slots. Reinstall ‘B’ screws from step 18. Tighten all (8) screws hand tight only.
(DO NOT OVERTIGHTEN)
23. Clean back of door with mild detergent or alcohol wipe to prepare the surface for the adhesive tape. Remove tape backing
from new LX3 mounting bracket (backside of bracket) and install bracket using (2) screws from step 17. Firmly push
bracket, where tape is located, into door for best tape adhesion.
Figure 15
24. Install the display power harness from ebox at ‘Z’ and the cove lighting harness from the 3rd circuit breaker at ‘Y’ onto the
terminal block. Note the wire colors and their locations installed on the terminal block.
Figure 16
Tape location
underneath
bracket
screw
Clean back
of door
Y
Z