DF/EDXXX Lid Kit Installation Instructions
Publication Number: 620919549
- 4 -
© 2001-2011, IMI Cornelius Inc.
CAUTION:
!
Use extreme care not to drill into the hopper. Use a drill stop to ensure that the drill bit does not penetrate deeper than
1/4” past the sheet metal. Failure to do so could result in a hole in the hopper, greatly reducing the efficiency of both
the dispenser and ice maker.
5.
Fasten the lid to the dispenser with four (4) #8 sheet metal screws (item 6), two on each side.
6.
Seal the ice maker to the top of the dispenser as follows:
A. Remove the ice maker front panel.
B. Position the ice maker base on the gasket (item 7) located on the lid assembly.
IMPORTANT: Do not slide the ice maker into position on the lid.
C. Lift and set the ice maker base onto the lid to avoid damaging the gasket seal.
7.
Install the brackets (item 5) on either the rear corners or on the back of the ice maker, using the brackets as
a template. Use care not to drill into any ice maker components (condenser, tubing, etc.) or into the ice
hopper. Be sure to overlap the lid assembly with the brackets, installing screws in both the lid assembly and
ice maker.
8.
Install the wireform bracket supplied with the bin–stat kit (item 4) through the 5/8” diameter hole in the bot-
tom of the ice maker, wrapping the eye of the wireform over the stud near the hole in the ice maker and
secure with the 8–32 nut provided (Figure 3 and Figure 4). Feed the bin–stat cap tube through the hole to
the end of the wireform bracket and wrap the tube around the end of the bracket several times, insuring
that the tube is secure.
CAUTION:
!
The bin–stat must not interfere with the agitator rotation not be in the path of the ice falling from the ice maker. If so,
bend the bracket out of the way.
9.
Apply the label (item 8) on the front of the cover.
