4
91718
CLEANING INSTRUCTIONS
WARNING: DISCONNECT POWER BEFORE CLEANING! Do not use metal scrapers, sharp
objects or abrasives on the ice storage hopper, top cover and the agitator disk, as damage
may result. Do not use solvents or other cleaning agents, as they may attack the plastic
material.
DISPENSER
1. Clean the ice dispenser interior at least once a month.
2. Lift off agitator assembly and wash and rinse it thoroughly.
3. Wash down the inside of the hopper and top cover with a mild detergent solution and rinse thoroughly to
remove all traces of detergent.
4. Replace the agitator.
5. Sanitize the inside of the hopper and agitator with a solution of 1/2 ounce of household bleach in 1 gallon of
water.
6. Remove ice chute cover as follows:
A. Flex sides outward to disengage lower pins.
B. Lift ice chute cover to disengage upper pins.
C. Lower ice chute cover down out of unit.
NOTE: It may be helpful to twist cover slightly.
7. Clean the inside of the ice chute and ice chute cover, with a mild detergent solution and rinse thoroughly to
remove all traces of detergent.
8. Reverse steps above to reassemble ice chute.
9. Sanitize as described in Step 5.
OPERATING INSTRUCTIONS
Fill hopper with ice and replace the lid. Pushing the dispenser lever will cause ice to flow from the ice chute. Ice
flow will continue until the lever is released. If ice does not dispense, see the troubleshooting guide to find the
cause.
NOTE: Use caution to avoid spilling ice when filling dispenser. Immediately clean up any spilled ice
from filling or operating the unit. To prevent contamination of ice, the lid must be installed on the unit
at all times.
MAINTENANCE
The following dispenser maintenance should be performed at the intervals indicated.
