TigoStarter K6
User Manual
Copyright © 2020 CoreTigo Ltd.
Page
14
of
32
2.3.2.2.
TigoMaster 2TS Evaluation - SW use
Please Note: Nucleo in K6 kit is already pre-programed with latest 2TS Mater program, steps below capture
the sequence required to flash new Application developed.
•
Open the STM32 ST-LINK Utility and connect to your device.
•
Click on Target > Program & Verify.
•
Browse to CoreTigo_SDK_Release_XX_YY_ZZZZ\SDK_Release_TigoMaster\bin\
•
select the TigoMasterExAppP06.hex file click start
.
Figure 8 - STM32 ST-LINK Utility
•
When flashed successfully you will get “verification…OK” notification in the log.
Figure 9 - STM32 ST-LINK Utility load complete
