VCX-4402-E Installation and Operating Instructions
Page 28
Example Command:
SATURATION 75
(increases color saturation from default)
TINT [n]
Adjusts color tint. The acceptable range is from –128 to 127.
Default: 0
Example Command:
TINT 10
(adjusts tint)
BITRATE [n]
This command adjusts the bit rate (in kbits/sec) of the encoded MPEG-4 video. This sets the
maximum rate (of the variable bit stream) encoded. If audio is in the MPEG-4 stream, then an additional
256 kbits/sec will be added to the rate set by this command.
Default: The default is set by the Profile command
Example Command:
BITRATE 2000
(Sets max bit rate to 2 Mbits/sec)
Note: This command should be issued AFTER the Profile command if the Profile command is used.
SAP Settings
The encoder is capable of multicasting SAP (Session Announcement Protocol RFC-2974) packets
with SDP (Session Description Protocol RFC-2327) content. There are a number of parameter settings
for configuring SAP. They are presented in this section. The user should refer to the referenced RFCs to
understand the significance of the SAP/SDP parameter settings.
SAP
This command is used to enable or disable the SAP multicast. ON or OFF are the permitted
parameters.
Default: OFF
Example:
SAP ON
SAPAUTHOR
This command is used to set the SDP (RFC-2327) author information. The parameter is an
ASCII string with a limitation of 30 characters.
Default: No text
SAPCOPYRIGHT
This command is used to set the SDP (RFC-2327) copyright information. The parameter is an
ASCII string with a limitation of 30 characters.
Default: No Text
