Questions? Give us a holler...
800-223-4332
tech
@
corbin.com
5. Find a convenient place to ground the
negative lead of the pigtail to your chassis. We
used the spot shown in Figure 9, but any location
with good contact to ground will work fine.
6.
Bundle loose wiring and secure it out of the
way with the included zip tie. Do not tighten
excessively or you may damage the wiring... just
secure it in place for cleanliness.
7. Plug in seat and test. To do this, just plug the
pigtail into the seat, turn on your ignition switch
and flip the switch on the saddle. If the switch
illuminates, the saddle heater is working.
8. Proceed with saddle mounting as outlined
above.
Enjoy your new saddle!
NOTE: The heater is controlled by the switch
along the side of the saddle. The temperature is
regulated by an internal thermostat when the
heater switch is turned on.
FIG 6
FIG 7
FIG 8
FIG 9
