Part Number:
BMW-K12R-F-E, BMW-K12R-R-E,
BMW-K12R-SMUG
Description:
Front and Rear Saddles
Fitment:
2005 BMW K1200 R
Revision:
2
Tools Required
Parts List
10mm socket or combination wrench
T25 torx socket wrench (to remove battery cable)
T45 torx socket wrench
5mm Allen key
Side cutters or scissors (for trimming zip ties)
Loctite® or similar
1 #A00673 Top mount bracket
1 #P10044 Bottom mount bracket
1 #CB-TWRHRN-36=01 Wiring pigtail with fuse
6 6mm flat washers
6 6mm hex head bolts
2 8” zip ties
NOTE:
We recommend the use of Loctite® or
other threadlock compound when assembling
parts on your motorcycle.
Saddle Installation:
1. Remove stock seat and stock saddle bags.
2. Install Corbin brackets on your motorcycle
chassis as shown in
Figure 1.
Use the included
bolts with a flat washer on each side. Tighten the
6mm bolt to 6 ft. lbs. Don’t forget the Loctite®!
3. Front saddle secures to the spool brackets
mounted on the front chassis of the bike and latch
mechanism in the rear. Simply slide the saddle
into place, nose-first, then lower onto the latch pin.
Push down until you get TWO clicks. To remove,
just squeeze the tab to release the lock.
4. Rear saddle installs with two tongues in the
front and latch in the rear. To remove, use the
stock key to unlock and pull up.
NOTE:
Front and rear seat brackets can be
adjusted to get the best fit.
Heater Installation:
1. Remove the top tank panel to expose the
battery.
Figure 2.
FIG 3
FIG 2
FIG 1
