CL33700 PWI/PIP Series Cylindrical Lock
11
Copyright © 2014 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
5) Installation Instructions (Continued)
Standard Cylinder Installation
Make sure cylinder tailpiece is aligned in same direction as cylinder bible.
Slide cylinder all the way into the lever.
For 6-pin cylinder: Fold retainer at hinge and press fit retainer halves together as shown.
For 7-pin cylinder: Break retrainer at hinge and discard spacer section. Also remove
black cylinder spacer from inside of chassis follback for clearance.
10. Install Wire Cover Plate:
Install the wire cover plate to the inside of the door above the lock body (Fig 9a).
Be careful not to pinch the wires when securing the cover plate.
Note: Wire cover is only required for wood doors
with the wire run channel on inside face of door.
Fig. 9b Detail
Fig. 9b
Inside Face of Door
Wire Cover
(2) #6 x 1/2”
Flat Head Security
Torx Wood Screws
This Side Down
Back Side of Wire
Cover Plate
Door Status Switch
9.
Installation and Removal of Lever and Standard Cylinders (continued):
Fig. 9a
(2) 3/32” Diameter
by 1/2” Deep Holes
Harness from
Lock Body
